芬兰Powernet 智能充电器/电源 MSR 2400W 系列

POWERNET 电源MSR 2400w

描述

2400 W 模块化电源系统

2400 W 模块化系统

每个模块的所有可用电压为 0…144VDC

U 和 I 从 0 到最大值可调

热插拔插件模块

电源或电池充电应用

用于远程监控的模块和电源警报

适用于重型应用的坚固结构

可选关断和输入过压

断开°C

POWERNET 电源MSR 2400w 系列

*) Max power 600W at DC input

Reduced power 55…200VAC or 78…200VDC

INPUT

 OUTPUT

Voltage Nominal voltages 0…144VDC / max 800W per module

Current Nominal current per module 0…30A / max 800W per module

Short circuit protection Rectifier modules Short circuit protected, electronic current limit

MCBs on front panel ADC7110/48 sub-rack 3 x 30A MCB in negative output

ADC7110/96 sub-rack 3 x 10A MCB in negative output

Output connector 3 terminal groups on rear panel 3-pole 10mm² screw terminal for each rectifier

(+ , - , PE)

Hot swap Series diode in each rectifier Hot-swap allowed,

Input and output switch at OFF poSITIon Series/parallel operations All modules can be connected in series or in parallel 

 CONTROLS

Input On the front panel Power switch with ON/OFF light

Output On the front panel MCB ON/OFF safety switch 

 ALARMS

Input failure U _in nom < appr. 150VAC Normally open and closed relay contacts Output failure Module failure or output switch off Relay contact and MCB auxiliary relay Alarm connector Rear panel Removable 12-pole 2.5mm² screw terminal

Pin configurations

1 Mains alarm COMMON

2 Mains alarm NO

3 Mains alarm NC

4 Parallel output alarm COMMON

5 Parallel output alarm NO *)

6 Series output alarm PSU1 COMMON

7 Series output alarm PSU1 NC *)

8 Series output alarm PSU2 COMMON

9 Series output alarm PSU2 NC *)

10 Series output alarm PSU3 COMMON

11 Series output alarm PSU3 NC *)

12 Not in use

*) Normally = Mains / PSU OK

 MECHANICAL